Overview：
The machine is the latest mill, developed by the company absorbing
advanced foreign technology. Its characteristics as follows:
1.Compared with the same-type milling machine, At the same power,
its output have been improved greatly(100% -200% increase), saving
energy consumption.
2 Increasing the dust collection device, effectively reducing dust
pollution;
3 Airlock discharge, separation screening elect the unqualified and
the automatic milling machine can reduce the labor intensity of the
workers’ operation.
4 The lid of the host can be opened, and it’s convenient to
overhaul and replace knife.
5．Use air-water to cool dually, reduce the temperature of the machine when working, groung
materials are not easy to change capability.
Scope of application:
This company absorbing foreign advanced technology has researched
and developed a series of Mill applicable to LEPE, LLDPE, EVA, PS,
rubber, wood flour, PTFE, ABS, PVC, VPE, such as automobile tire,
rubber or other plastic after the successful test of the mill. The
professional plastic products factores have practiced that
operation, ground powder in the recovery process to add 20 percent
to 30 percent, the chemical and physical properties of the
indicators of products remain unchanged. Therefore it is the best
equipment for the plastic products factory to reduce savings and
solve defective accumulation of waste.
Maintenance:
1.Regularly open the lid, check the blade, fasten nut and check the
lid-nut wether loose or not. if loose it must be tighten.
2.The axletree of the Lubrication host use lithium-MoS2 (Mos2)
grease;
3.Air blower pipe need to check the blades and pipe wall monthly, and
to remove its compacted dust
4.Blade in use for some time, its force be ground into larger fillet,
then removed the knife and transfer 180 degrees, after fastening it
can continue to use
Attention to production safety issues:
1Manual familiar with the content and the role of electrical button,
the direction of rotation of the host must comply with the
direction of the arrow marked on the cast belt, which is prohibited
upside down;
2Air blower should be start beforehand (attention to the direction
of rotation), to be in normal operation,start the host to the
normal speed, and then start feeding;
3When the production began, automatic Feeding machine open to small
as long as the materials can be expected to get in , and then
slowly speed up the feeding machine. The load conditions of a
machine are usually in about 60 A suitable, for the Ammeter
measurement of the Electronic Control panel is 37 KW +4 KW and
Line, so the maximum total amount of the current is 75 A. the
current should swing between 55-65 A In the normal working
4Choice of materials requirements: Material shall not exceed the
maximum tablets of 8 mm, avoid metals, stones and others invasive
machine, so as not to damage knife-grinding teeth plate aggravately
5It should be stopped immediately if abnormal noise appear during
operation. Open the lid to inspect, after troubleshooting After the
adjustment of knife-gap it can continue to produce
6Turn off the automatic feeding machine before the host, Determine
when the host without material, turn off the host or shaker , and
then turn off the air blower
